If constant use does cause your hinges to drop, your door may need some minor hinge adjustment. Don’t worry, doing this from time to time is natural. You then need to sand down the door all over as that will further help the paint to adhere. After you have sanded it, you then need to give it a thorough wipe down to remove the dust. Painting Apply Polytrol using a fine wire wool (000 grade) soaked in Polytrol and allow it to work for 10-20 minutes. Wipe off any excess Polytrol with a clean lint-free cloth. Leave to dry. NatWest, RBS and Ulster Bank to close at least 172 branches in 2023/24 – here's the full list, plus alternatives This is obviously very different to traditional timber doors that have a coating of paint over the top as a finishing touch.

Apply primer to metallic and bare wood areas. It is best to use oil-based paint for a perfect finish. Clean the surface with warm soapy water and rinse thoroughly or use an appropriate solvent (follow manufacturer’s instructions). Leave the surface to dry for a minimum of 24 hours. Application of Polytrol Colour Restorer General directions The warm, soapy water can now be used on the frame of the door. Be sure to open the door to get all around the edges of the frames and get any of that concealed dirt that may affect the closing of your door if allowed to build up.Applying the Polytrol to a wet surface will not produce the desired effect and could negatively impact the door. The colour of your front door is one of the ways in which you can make a statement about your home. It's the first thing guests see as they enter your house so the door colour you choose should make a good first impression. Some installers use WD40 to help give the door that extra shine; however, the effect will not last for long and, in the end, will not do any significant damage, but it will not do much good either. Whereas some people will tell you that oil-based paints work best, others will argue that solvent paints are best.

One of the reasons that they are made with a composition of multiple materials is so that they can withstand the different abrasive weather that every door faces throughout a year. If you’ve been affected in this way, take a look at our top tips – they might provide you with a simple solution to the issue! Warping, bowing or swelling Want an updated design, as well as a new colour? Get in touch with our friendly team for a no-obligation free quote and advice. We're always happy to chat windows and doors! This will help to make sure you remove all dirt, grime, oil and any other residue that may make it harder for the paint to adhere to the surface.For more information about Paul and his company please see his bio below. We couldn’t wait to see the photos and share them with our other customers. I’m sure you’ll agree that the transformation is nothing short of marvellous!

Before we get started, make sure you have everything you need to paint your old door. You will need: If the door is only lightly soiled, a simple wash with warm soapy water, a gentle scrub and thorough rinse might be all that is needed. When someone arrives at your home, your front door is one of the first things that they’ll see. A tired, faded front door can make even the most beautiful of homes seem a little neglected. Afterwards, rinse the door thoroughly with clean water. You can try using gentle rubbing alcohol if you have any stubborn stains. Clean all around the frame, as this can affect how the door opens.A heavily scratched front door can hurt the entire aesthetic of your home. It can make the entrance to your house look tired and in need of repair. The door didn’t take us longer than 20 minutes so we could do it all in one go but if it will take you any longer than 20 minutes, you will need to work within areas that can be completed within this time-frame. When using the Polytrol 250ml spray can, simply spray on liberally, wipe off any excess and leave to dry. Applying Polytrol to plastic, gelcoat, tiles, painted surfaces etc. Polytrol works by saturating deep into the surface of the door, not by leaving a coating, so removal of the excess Polytrol is important.